This guide covers security+ lab 01 step by step, with every setting in the order you will use it. This first lab builds the two machines every later exercise uses: Kali Linux, the attacker/testing workstation, and Windows 10, the target. When both VMs are installed and can reach each other on an isolated network, you are ready for the whole Security+ lab series.

dns LAB TOPOLOGY & PREREQUISITES
# example values used while writing and testing this guide
LAB VM
ATTACK VM
TARGETS
01constructionSecurity+ lab 01: Step 1: Install Kali Linux
Download the Kali Linux installer image and create the VM in VMware Workstation or VirtualBox: Linux 64-bit guest, at least 2 GB RAM and 20 GB disk. Follow the full walkthrough in How to Install Kali Linux. During setup choose a hostname and username you will remember, and when the desktop loads run sudo apt update && sudo apt full-upgrade -y so the tools are current.
02downloadStep 2: Install Windows 10
Create a second VM: Windows 10 x64, 2-4 GB RAM, 40+ GB disk. The Windows 10 evaluation ISO from Microsoft works well for labs — see Before You Begin for where to get it and the settings checklist. Complete setup, note the local administrator credentials, and let it sit on the desktop. In short, Security+ lab 01 works best when you follow the order above and verify each step.
03usbStep 3: Wire the Lab Network
Put both VMs on an isolated network:
- VMware Workstation: set both NICs to LAN segment (create one named
security-lab), or use Host-only for both - VirtualBox: attach both to the same Internal Network or Host-only Adapter
Give each machine a static IP on a lab-only subnet (for example Kali 192.168.50.10, Windows 192.168.50.20). Isolation matters: none of these machines should be reachable from your home network or the internet.
04terminalStep 4: Verify and Snapshot
From Kali, ping the Windows VM. If it fails, check that Windows’ network profile is set to Private, its firewall allows ICMP, and both adapters are on the same segment. When ping succeeds, take a snapshot of both VMs — you will restore these clean states before every future lab. In short, Security+ lab 01 works best when you follow the order above and verify each step.
Related Content
Watch: How to Install Kali Linux
Because some steps are easier to copy from video, this companion walkthrough mirrors the lab above. Also, the chapter pills follow the same order as the steps.
CompTIA Security+ Lab 02: Network Reconnaissance and Vulnerability Scanning
Finish this lab, then continue down the track. Each guide builds on the one before it.